Swimming pool splated cover roller system
Purpose - application
The slat pool covering ASPAR is intended for protection of pool content against penetration of impurities, fall of rodents, frogs or insects; heat dissipation (reduction in power consumption necessary for water heating); and provision of a prolonged bathing season of outdoor pools. It hinders water evaporation and increases safety of children and domestic animals (prevents falling into open water).
The slat blind is controlled mechanically by means of an electric winding device working with safe voltage. It is controlled remotely or manually with a switch.
According to the structural design, it can be located above or under water.
Technical data
Voltage system 1AC+PE+N, 230 V, 50 Hz
Installed load 240 W
Rated current 10 A
Protection class IP 55
Electric motor 24 V DC
Equivalent noise level not exceeding 70 dB(A)
Equipment transport
The slat pool covering is transported on a special pallet manufactured for this purpose. The entire equipment is covered in foil protecting it from dust and moisture.
Immediately after takeover of the goods (consignment), check all the parts delivered against the list. If some parts are missing or have nonconforming dimensions, you can make a written claim within 5 days from the date of takeover of the goods (consignment). Later claims will not be taken into consideration.
Unless otherwise agreed, the supplier chooses common methods of packaging and delivery of goods at his/her own discretion. By the customer’s request, special packaging claims can be met at his/her own expense added to the delivery price.
The supplier is not responsible for damage caused by transport of the goods. In case of personal takeover, the customer or his agent bears the responsibility for the goods.
Connection to the mains can only be done by an authorized person with proper qualification. The electric equipment of the pool blind is connected to the pool main switchboard equipped acc. to provisions of ČSN 33 2000-7-702 by an additional protection by a current circuit breaker with rated actuating differential current not exceeding 30 mA. Safe voltage source protection (not included in the delivery). The safe voltage source of 24 V must be installed outside zone 0 (pool interior), 1 (delimited by zone 0 and the vertical plane 2 m from the pool edge) and 2 (delimited by the external vertical plane of zone 1 and the plane parallel with it at the distance of 1.5m) - see ČSN 33 2000-7-702. In zones 0 and 1, the circuits must not have any metal case or cover. The cables must permanently resist external effects at the installation place, and must be protected against damage. During idle run, check that the winding drum rotates freely.
Environment requirements
The slat pool covering can only be mounted if the pool has already been completed in the pool hall or there (in its surroundings) will be no construction or other activities which could damage the equipment (dust, falling objects, paint, heat or other dirt, etc.).
The pool water must meet hygienic and biological parameters of pool water (water with high content of iron or other metals, or chemically untreated, may stain the slats).
